JVC RC-QC7 - Page 28

RC-QC7 seena
«CD Traverse Mechanism Section )
mw Removing the CD Mechanism Section
1.
Remove
the
CD
traverse
mechanism
assembly
from
the
Ly
‘
body.
ae
S
fo]
Caution
1:
Prior
to
removing
CD
traverse
mechanism
7
UW
7
assembly,
be
sure
to
set
all
of
the
sub-
trays
[A]
position
re
Slid
cam
(L)
to
the
[STOP]
mode.
Caution
2:
In
the
case
of
removing
the
mechanism
Fig.
5-27
when this system has been set to the
[PLAY] mode, the slide cam L on the left
side of the CD traverse mechanism should
be moved in the arrow A direction and
positioned to [A]. Under this condition, the
CD traverse mechanism will be lowered to
the position as shown in Fig. 5- 27).
Remove
the
four
screws
@
retaining
the
top
cover
(See
Fig. 5- 28).
.
After
pulling
out
the
rod
from
the
clamper,
remove
it
together
with
the
top
cover
(See
Figs.
5-
28
and
5-
28a).
A. Pull out the CD tray.
5.
Remove
the
one
screw
@
retaining
the
clamper
(See
Fig. 5-29).
6.
After
moving
the
clamper
in
the
arrow
B
direction
and
shifting
it
in
the
arrow
C
direction,
take
it
out
from
the
engagement section [B](See Fig. 5-29).
Top cover
Clamper
nN
wo
Clamper
Fig. 5-28
=
Engagement
section
Clamper
Top cover
28 (No.10036)