JVC RC-W410 - Board and Mechanism Removal Procedures; Component Removal: Buttons and Power Board

=
Tuner Board
Draw out the tuner board along the groove of the front
cabinet ass’y.
Main Board and Power Amplifier Board
. Remove three knobs of the slide switches: TAPE/FM
MODE, FUNCTION and 3D selectors.
. Release the wire from three wire clamps located by the
right speaker.
. Remove adhesive tape securing the wire to the main
board.
. Remove two screws © (M3 x 45) and ® (M3 x 45,
black) securing the main board and power amplifier.
. Detach the PHONES jack first, then the volume control
and SEA switch, etc. one after another, and lastly take
off the boards.
. Disconnect connectors CN103, CN902, CN101, CN102
and CN401 from the Main board.
Mechanism Ass’y
. Remove the tuner board and amplifier board.
. Remove nine screws (M3 x 10) and @) (M3 x 25)
securing the mechanism ass’y.
. Draw out the Rec. lever.
Operation Buttons
Remove ten screws (M2 x 4) securing operation
buttons to the mechanism.
Synthesizer/LCD Board
Remove two screws @ (M3 x 8) securing the Synthesizer/
LCD board.
Power Transformer and Power Supply Board (Fig. 6-2b)
. Remove three screws ® retaining the power transformer
and power supply board.
. Remove two screws from transformer bracket.
(When re-assembling, make sure of the correct direction
to set the transformer bracket.)
RC-W410. secon
M3x25 M3x10
(No. 1768) 9