JVC RC-W410 - Removal of Main Parts; Rear Cabinet Removal; Speaker Unit and Hyper-Bass Sound Box Removal

RC-W410 B/E/G/GI/V/VX © |
6) Removal of Main Parts
Rear Cabinet Ass’y
‘
Remove
six
screws
(1)
(M3
x
20)
and
@)
(M3
x
44)
which
secure
the
rear
cabinet
ass’y
at
the
points
indicated
by
A
marks.
2.
In
the
course
of
detaching
the
rear
cabinet
ass’y,
dis-
connect
the
antenna
lead
which
is
wired
to
the
tuner
board
from
TP1.
3.
Disconnect
a
connector
CN901
from
the
power
amplifier
board,
M3x 20
Fig. 6-1
B® Speaker Unit for Hyper-Bass Sound
1. Release the wire between the battery contact board and
the
power
supply
board
from
the
guide
for
wire
arrange-
ment.
2, Release the wire from three wire clamps located by the
right speaker.
3. Remove five screws ) (M3 x 16) and six screws @ (m3
x
16)
securing
the
hyper-bass
sound
box.
Therefore,
the
speaker unit can be seen.
4. By removing eight screws ® (M3 x 16) from the hyper-
bass
sound
box,
the
speaker
unit
can
be
taken
offm3
x
16
Guide for wire
arrangement (3) M3 x 16
Fig. 6-2b AB
8 (No. 1768)