EasyManua.ls Logo

JVC RX-1024VBK - Page 3

JVC RX-1024VBK
76 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
G-2
To get the best DSP (Digital Signal Processor) effect in your listening room, note the speaker
settings you have set on the table below for future reference (even though the receiver
memorizes the settings until you change them).
For actual setting procedures, see pages 19 to 21.
Speakers Setting
Front Speakers LARGE SMALL
Center Speaker LARGE SMALL NONE
Rear Speaker LARGE SMALL NONE
Center Delay Set to [ msec] (Select from 0 to 5 msec)
Rear Delay Set to [ msec] (Select from 0 to 15 msec)
Crossover Frequency 80 Hz 100 Hz 120 Hz
LFE Attenuator 0 dB 10 dB
Dynamic Range Compression
OFF MID MAX
Note:
If the power cord is unplugged
or a power failure occurs, all
preset settings will be erased in
a few days.
Warranty.RX-1024V[J]/1.PM5 98.5.12, 0:45 PM2

Table of Contents

Related product manuals