RX-6030VBK
1-6 (No.22026)
2.5 Removing the DSP board, audio input board, DVD board and video board
(See Fig.7)
• Prior to performing the following procedure, remove the top
cover and rear panel.
(1) From the top side of the main body, disconnect the DSP
board from the connector CN481 on the audio board.
(2) Disconnect the audio input board from the connector
CN421 on the audio board.
(3) Disconnect the DVD board from the connector CN431 on
the audio board.
(4) Disconnect the video board from the connector CN441 on
the audio board.
Fig.7
2.6 Removing the S Video board and tuner board
(See Fig.8)
• Prior to performing the following procedure, remove the top
cover and rear panel.
(1) From the top side of the main body, disconnect the parallel
wire from the connector CN511 on the S Video board.
(2) Disconnect the S Video board from the connector CN461
on the audio board.
(3) Remove the tie band fixing the parallel wires, disconnect
the tuner board from the connector CN411 on the audio
board.
Fig.8
CN481
Audio board
DVD board
Video board
CN421
To Next Page
Loading...
Need help?
General
