JVC SR-DVM700EU - 4.9 Positioning the tension pole

1-32 (No.YD091)
4.9 Positioning the tension pole
See Fig.4-9-1.
Fig.4-9-1
4.9.1 Adjustment Method
Note:
• Remove the cassette housing assembly in advance.
(1) Set the mechanism mode to the PLAY mode. (See
4.2.2 Mechanism modes)
(2) Loosen a screw [A].
(3) Check the location of the tip (section [B]) of the ten-
sion arm assembly to make sure that it is within area
[C]. If it is located outside, turn part [D] to bring it
within the specified area.
(4) Tighten the screw [A].
Note :
Tightening torque for the screw [A] : 0.06 N.m (0.6kgf.cm)
[
D
] section
Tension arm sub
assembly
screw [A]
[
C
]
[
B
] section