18
Basic operations
1 Press SPK LEVEL to show the
target speaker indication on the
display window.
Each time you press the button, the indication of the
speakers changes as follows:
2 Press +/– to adjust the output
level from –6 to +6 while speaker
indication is displayed.
NOTE
• You can also make adjustments by using the setup menu
shown on the TV screen. (See page 30.)
• The adjustments take effect for all sources.
The system can be accommodated to your TV’s
scanning mode when playing back a JPEG/
MPEG-1/MPEG-2/ASF file in the USB mass
storage class device.
NOTE
• To use the system in the progressive mode, it is required that
the center unit is connected to the TV by using component
video cord (not supplied). (See page 9.)
7While USB MEMORY playback is stopped
1 Press and hold SCAN MODE for 2
seconds.
The current setting appears on the display window.
2 Press 2/3 to select the desired
mode.
• PA L : Select when your TV supports the PAL
interlaced video input only.
• PAL PRG : Select when your TV equipped with
component jacks supports the PAL progressive video
input.
• NTSC: Select when your TV supports the NTSC
interlaced video input only.
• NTSC PRG: Select when your TV equipped with
component jacks supports the NTSC progressive
video input.
You can get better picture quality in PAL PRG, NTSC
PRG mode than in PAL, NTSC mode.
3 Press ENTER while the selected
mode is displayed.
When “PAL PRG” or “NTSC PRG” is selected, the
PROGRESSIVE indicator lights on the display window.
NOTE
• Although the picture may be distorted when you press
ENTER, this is not a malfunction of the system.
Adjusting the output level of
the speakers and subwoofer
FRNT L (Front left speaker) Z FRNT R (Front right
speaker) Z CENTER (Center speaker) Z SURR L
(Surround left speaker) Z SURR R (Surround right
speaker) Z SUBWFR (Subwoofer) Z (back to the
beginning)
Changing the scanning mode
• There are some progressive TVs and High-
Definition TVs that are not fully compatible with
this system, resulting in an unnatural picture when
playing back a JPEG/MPEG-1/MPEG-2/ASF file in
the progressive scanning mode. In such a case,
change the scanning mode to “PAL” or “NTSC.”
• All JVC progressive TVs and High-Definition TVs
are fully compatible with this system.
See page 16 for button locations.
TH-L1[U].book Page 18 Friday, June 1, 2007 9:34 AM
To Next Page
Loading...
