JVC TH-LB2-B

2
CONTENTS
Introduction ................................. 1
Playable iPod models .................................. 1
Notes on handling ........................................ 1
Supplied accessories.................................... 2
Getting started ............................. 3
Preparing the remote control .................. 3
Installing the unit .......................................... 3
Using the core filter ...................................... 5
Connecting the TV — viewing the
video/picture from iPod on your TV ... 5
Connecting external components .......... 6
Connecting the power cord ...................... 6
Operations .................................... 6
Basic operation .............................................. 6
Using the surround mode.......................... 7
Adjusting the sound level .......................... 7
Playing back iPod .......................................... 7
Buttons and lamps on the front
panel ............................................................... 8
Troubleshooting .......................... 9
Specifications ............................... 10
Do not place anything on top of the System. Doing so may cause •
the System to fall, causing malfunctioning and/or injury.
The manufacturer accepts absolutely no liability for any accidents •
or damage resulting from inadequate assembly or mounting,
insufficient strength of attachment, misuse or abuse, or natural
disasters.
If water gets inside the System
Turn the System off and disconnect the power cord from the wall
outlet, then call the store where you purchased this System. Using
the System in this condition may cause a fire or electrical shock.
Supplied accessories
Check to make sure you have all of the supplied accessories.
If anything is missing, contact your dealer immediately.
Remote control RM-STHLB2E (× 1)•
AC adaptor (AA-R1904) (× 1)•
AC power cord•
3-pin plug type (for U.K.) (× 1) –
2-pin plug type (for other countries) (× 1) –
Lithium coin battery CR2025 (× 1)•
The battery has been installed in the remote control when –
shipped from the factory.
Core filter (× 3)•
TV remote pass through cable (× 1)•
Double-sided adhesive tape (× 1)•
Stand System•
Stand (× 2)* –
Stand base (× 2)* –
Foot spacer (× 2)* –
Screw for stand and stand base (M2.6 × 10 mm) (× 8) –
* These have been binded together when shipped from the factory.
Remove the tape before installation.
Thank you for purchasing a JVC product. Before operation,
please read the instructions carefully.
EN_TH-LB2[E]f.indd 2EN_TH-LB2[E]f.indd 2 12/28/11 9:12:09 AM12/28/11 9:12:09 AM