13
Installing the Rubber Feet
You can extend the height of the unit.
1. Turn the unit upside down.
2. Remove the backing paper from the rubber foot.
Wall Mounting
• Installation must be carried out by qualied personnel only. Incorrect assembly can result in severe
personal injury and property damage (if you intend to install this product yourself, you must check
for installations such as electrical wiring and plumbing that may be buried inside the wall). It is the
installer’s responsibility to verify that the wall will safely support the total load of the Soundbar and
wall brackets.
• Additional tools (not included) are required for the installation.
• Do not overtighten screws.
• Keep this instruction manual for future reference.
• Use an electronic stud nder to check the wall type before drilling and mounting.
Ensure the surface is clean prior to sticking the rubber
foot to the bottom of the unit.
1. Remove the screws from the main unit.
screw out
3. Stick the rubber foot to the bottom of the unit as shown in the illustration below.
TH-WL701B_703B_IB_140418_Annie.indd 13 18/4/14 7:14 pm
To Next Page
Loading...
Need help?
General
