30
FM Operation
1. Press SOURCE on the unit repeatedly or FM on the remote control to select FM radio.
2. Press MENU to display the FM menu. Press
/ to scroll through the options then
press
/OK to conrm.
Scan Allows the auto scan function to be able to nd weaker
signals or strong signals.
Audio Select Stereo or Mono.
System Reset your unit back to the factory settings.
Scanning for Radio Stations
The unit will automatically select a FM radio station with a good signal.
1. While listening to an FM station, press SCAN button to activate automatic
programming. All available stations will be programmed in the order of waveband
reception strength.
2. The rst programmed radio station is played automatically.
3. To select and listen to a saved radio station, press
/ to skip to the previous / next
preset radio station.
Auto Tuning
Press and hold the / for a few seconds, the tuner will start searching for a station. The
tuner will stop searching after tuning into a radio station.
Manual Tuning
Press / buttons repeatedly to search for the desired frequency reception. Each press
the / buttons will adjust the frequency by 0.05MHz.
• The search may not stop at a station with a very weak signal.
• If reception is still poor, try to adjust the DAB / FM aerial location.
Presetting Stations Manually
You can store up to 20 of your favourite stations to the memory. This will enable you to
access your favourite stations quickly and easily.
1. To store a preset station, you must rst be listening to the station that you would like to
save, press PROG. The preset number will ash on the display.
2. Then press
to select your desired preset station number and then press PROG to
conrm.
3. The station will be stored and the screen will then show “STORE”.
TH-WL701B_703B_IB_140418_Annie.indd 30 18/4/14 7:14 pm
To Next Page
Loading...
Need help?
General
