27
DAB Operation
1. Press SOURCE on the unit repeatedly or DAB on the remote control to select DAB
radio.
2. Press MENU to display the DAB menu. Press
to scroll through the options then
press /OK to conrm.
Full Scan Perform auto scan.
System Reset your unit back to the factory settings.
Auto Scan
The auto scan will search for the entire DAB Band III channels. After the scan has nished,
the rst alphanumerically found station will be automatically selected.
1. Press MENU to enter the DAB menu, then press
to select “FULL SCAN”. Press
/OK to conrm. The display will show “SCAN ...” that indicates the progress of the
scan and the amount of stations that have been found so far.
Alternatively directly press SCAN on the unit or on the remote control to perform a full scan.
• The NFC function only works with mobile devices that support NFC technology.
• You may need to remove your mobile device case to connect using NFC.
2. Once the scan has nished, the unit will display the total number of stations have
been found and a list of the found stations. All stations that have been found will be
automatically stored.
3. To explore the found stations, press
to the selected station.
Full auto scan will not replace the DAB stations in memory. If you want to remove all the previously
scanned stations, system reset is required.
NFC (Near Field Communication) Operation
Pair your NFC-enabled mobile device directly with this unit by just a single tap.
1. Activate NFC on your mobile device.
2. Tap the mobile device on the
icon of the unit. The device vibrates or a message pops
up. Your unit will switch to Bluetooth® mode automatically.
3. Operate your mobile device directly for playback features.
4. To disconnect, tap the mobile device on the
icon of the unit to disconnect or disable
NFC from your mobile device.
TH-WL701B_703B_IB_140418_Annie.indd 27 18/4/14 7:14 pm
To Next Page
Loading...
Need help?
General
