11
GB
Wall Mounting
• Installation must be carried out by qualied personnel only. Incorrect assembly can result in severe
personal injury and property damage (if you intend to install this product yourself, you must check
for installations such as electrical wiring and plumbing that may be buried inside the wall). It is the
installer’s responsibility to verify that the wall will safely support the total load of the Soundbar.
• Additional tools (not included) are required for the installation.
• Do not overtighten screws.
• Keep this instruction manual for future reference.
• Use an electronic stud nder to check the wall type before drilling and mounting.
1. Attached the wall brackets (included) to the main unit with the supplied screws.
618 mm
Wall (Front view)
2. Drill 2 parallel holes (Ø 3-8 mm each according to wall type) in the wall. The distance
between the holes should be 618 mm.
Installing the Foot Pads
Ensure all cables to the main unit are disconnected before installing or removing the foot pads.
To Next Page
Loading...
Need help?
General
