18
GB
This instruction manual explains the basic instructions for operating this unit. Unless otherwise stated, all
operations described are based on remote control use.
General Operation
Standby / ON
When you rst connect the unit to the mains socket, the unit will be in Standby mode.
• During Standby mode, the POWER indicator of the subwoofer will be o. Press
on the unit or on the remote control to switch the unit on. The display will show
“WELCOME“, and then the last used mode. The sound level will x on level 15 after
every time the unit is switched on.
• After the unit is idle for about 10 seconds, the display will show “--“. Press any button
(except and MUTE) to exit the idle mode.
• Press on the unit or on the remote control again to switch the unit back to Standby
mode. The display will show “GOODBYE“, and then turn o.
Alternatively,
• press AUX 1/AUX2 on the remote control repeatedly to select AUX 1/AUX 2 mode.
• press OPT on the remote control repeatedly to select OPTICAL mode.
• press COAX on the remote control repeatedly to select COAXIAL mode.
• Press on the remote control repeatedly to select BT (Bluetooth®) mode directly.
• To switch the unit o completely, remove the mains plug from the mains socket.
• Please turn the unit o completely to save energy when not in use.
Selecting Modes
Press SOURCE on the unit or remote control repeatedly to select between AUX 1, AUX 2,
BT (Bluetooth®), OPTICAL and COAXIAL modes.
Automatic Power O Function
The unit automatically turns to Standby mode after about 10 minutes if the TV or the
external unit is disconnected, switched o or the volume is too close to mute.
To Next Page
Loading...
Need help?
General
