JVC UX-D457S - Clock Operation; Manually Setting the Clock; Time Display; Clock Synchronization

18
Time Display
• During standby mode, press CLOCK to display the clock for approx 90 seconds.
• While the unit is on, press CLOCK to display the clock for few seconds.
Clock Synchronization
When in STANDBY mode, press the CLOCK button to show the clock time on the display.
Press and hold button on the remote control, then press / buttons to select RADIO to
synchronize or OFF for manual setting.
Sleep Timer
Use the sleep timer to turn the unit o after a certain number of minutes when in play
mode. By setting the sleep timer, you can fall asleep to music and know that your unit will
turn o by itself rather than play all night. The clock must be correctly set for the timer to
operate correctly.
1. In On mode, press TIMER/SLEEP repeatedly to select your desired number of minutes.
The number of minutes shown will display in this sequence:
SLEEP 15SLEEPOFF SLEEP 30
SLEEP 120 SLEEP 90 SLEEP 60
2. Stop pressing the SLEEP button when your desired number of minutes is displayed.
The sleep timer is now set.
3. Press TIMER/SLEEP to view the remaining time before switch o.
4. To cancel the sleep timer, press TIMER/SLEEP repeatedly until “SLEEPOFF” shows on
the display.
Clock Operation
In DAB / RDS station, the unit can synchronize with time transmitted by DAB / RDS station
(with CT information) automatically.
Manually Setting the Clock
Manual setting the clock can only be done in Standby mode.
1. In Standby mode, press the CLOCK button to show the clock time on the display. Press
and hold the CLOCK button on the remote control until CLOCK SET scrolls across the
display.
2. The hour indicator will blink. Press
/ buttons to set the hour.
3. Press CLOCK or ENTER on the remote control to conrm and the minute indicator will
blink.
4. Press
/ buttons to set the minute.
5. Press the
button on the unit or the / PAIR button on the remote control to switch
between 12/24 hour format.
6. Press the CLOCK or ENTER button on the remote control to conrm.
• If no button is pressed in approx. 60 seconds, the unit exits clock setting mode automatically.
• If a power failure occurs or the unit is disconnected from the mains, the clock setting will be lost.