7
Listening to the Radio
To select the AM tuner interval spacing
Some countries space AM sations 9 kHz apart, and other
countries use 10 kHz spacing.
1 Select “AM,” then turn off (standby) the System.
2 Select the AM tuner interval spacing.
To select the band (FM or AM)
To tune in to a station
While FM or AM is selected...
Station searching starts and the frequency indication start
changing on the display.
When a station (frequency) with sufficient signal strength is
found, the searching stops.
• When you repeatedly press the button, the frequency
changes step by step.
To manually stop searching,
press either button.
If the FM station reception is poor
The ST indicator disappears on the display. Reception will
improve though stereo effect is lost—Monaural reception.
To restore the stereo effect,
press the button again (the ST
indicator lights).
If the beats are heard while listening
to AM station
Select from “BEAT CUT 1” to “BEAT CUT 4,” whichever
reduce the beats.
To preset the stations
You can preset 30 FM and 15 AM stations.
1 Tune in to a station you want to preset.
• You can also store the monaural reception mode for
FM preset stations if selected.
2 Activate the preset number entry mode.
• Finish the following process while the indication on the
display is flashing.
3 Select a preset number for the station you store.
4 Store the station.
To select 9 kHz:
To select 10 kHz:
Remote control:
Main unit:
INFO
Main Unit
ONLY
(while holding...)
(while holding...)
FM AM
AUX
FM AM
AUX
2 sec.
Decreases the frequency.
Increases the frequency.
Examples:
To select preset number 5, press
5.
To select preset number 10, press
10.
To select preset number 15, press
10, 1, then 5.
To select preset number 30, press
10, 3, then 0.
Remote
ONLY
Remote
ONLY
BEAT CUT 1
BEAT CUT 4
BEAT CUT 2
BEAT CUT 3
Remote
ONLY
UX-DM8[U].book Page 7 Monday, June 4, 2007 8:20 PM
To Next Page
Loading...
Need help?
General
