JVC UX-DM8 - Daily Operations - Timers and Clock; Setting the System Clock; Automatic Power Off Features

14
Setting the Clock
Without setting the built-in clock, you cannot use Recording
or Playback Timer (see pages 34 and 36).
• To exit from setting the clock, press CLOCK/TIMER as
required.
• To correct a mis-entry during the process, press CANCEL
or CLOCK/TIMER. You can return to the previous step.
1 Activate the clock setting mode.
• If you have already adjusted the clock before, press the
button repeatedly until the clock setting mode is
selected (see page 34).
2 Set the time and day.
• Adjust the hour, then the minute, then the day of the
week.
Now the built-in clock starts working.
To check the current clock time during play
*
1
Only while playing back an MP3/WMA/WAV track .
*
2
Only while playing back the built-in memory or USB
device.
*
3
Not displayed while “MEMORY” is selected as a source.
*
4
Not displayed while “iPod” or “USB” is selected as a
source.
Turning Off the Power Automatically
Auto Standby
This function only available for CD, built-in memory, USB,
iPod and AUX.
When Auto Standby is in use, the A.STBY indicator lights
on the display.
When the playback stops, the A.STBY indicator starts
flashing. If no operation is done while the indicator is
flashing (for about 3 minutes), the System turns off
(standby) automatically.
Sleep Timer
You can set the shut-off time so that you can go to bed
without turning it off yourself.
1 Specify the time (in minutes).
2 Wait until the set time disappears.
To check the time remaining until the shut-off time, press
SLEEP.
• If you press the button repeatedly, you can change
the shut-off time.
Remote
ONLY
INFO
Source
information
Clock
Track title*
1
Group title*
2
MEM REMAIN
(MEMORY Remaining Time)
*
3
USB REMAIN
(USB Remaining Time)
*
4
Remote
ONLY
SET
CANCEL
(Canceled)
10 20 30 60 90 120 150
180
Canceled
UX-DM8[U].book Page 14 Monday, June 4, 2007 8:20 PM