6
Daily Operations—Playback
1 Turn on the power.
The STANDBY lamp on the main unit turns off.
• The System also turns on by pressing one of the
source buttons.
• The System turns on and “AUX” is selected as the
source automatically by starting playback on the
device connected to AUX jack when QP Link is
activated. (See page 11 for details.)
2 Select the source.
Playback automatically starts if the selected source is
ready.
3 Adjust the volume.
To turn off (standby) the System
You can reduce power consumption by using DIMMER
while on standby to turn the display off.
• When the display is turned off, QP Link does not work.
In this manual, operations using the remote control are
mainly explained; however, you can use the buttons
and controls on the main unit if they have the same (or
similar) name and marks.
1
2
1
3
REPEAT
3
FM/PLAY MODE
4,¢
7
2
SET
ENTER
QP LINK
GROUP SELECT
GROUP SKIP
TITLE/EDIT
Number
buttons
Remote control
The STANDBY lamp on the
main unit lights in red.
• A small amount of power is
always consumed even while
on standby.
For private listening
Connect a pair of headphones to the PHONES jack on the
main unit. The sound will no longer come out of the
speakers. Be sure to turn down the volume before
connecting or putting on the headphones.
• Disconnecting the headphones will activate the
speakers again.
DO NOT turn off (standby) the System with
the volume set to an extremely high level;
otherwise, the sudden blast of sound may
damage your hearing, speakers and/or
headphones when you turn on the System or
start playback.
UX-DM8[U].book Page 6 Monday, June 4, 2007 8:20 PM
To Next Page
Loading...
