JVC UX-DM8 - Advanced Playback Operations - Memory and USB; Programming Tracks from Memory;USB

16
To program the playing order of tracks on the
built-in memory and USB device
You can arrange the playing order of the tracks in the
built-in memory and USB device (up to 999) before you start
playback.
1 Start and stop playback.
2 Select the desired track.
• You can also use the number buttons to select the track.
3 Program the desired track.
• If you try to entry a track after registering 999 tracks,
“PROGRAM FULL” appears on the display and the
track will not be programmed.
4 Repeat the above step 2 and 3.
5 Activate Program Play.
6 Start playback.
To check the programmed contents
Before or after playback...
To modify the program
Before or after playback...
To exit from Program Play
Before or after playback...
* Appears only when “MEMORY” or “USB” is selected as
a source.
When program the tracks
on the USB device
When program the tracks
on the built-in memory
Program number
PROGRAM RANDOM
GROUP
RANDOM
GROUP
Canceled
Number of the programmed tracks
Group number of a track
that programmed last
Track number of a track that
programmed last
Playback starts in the order
you have programmed.
To skip: To pause: To stop:
To release, press again.
To erase the last track/file: To erase the entire
program:
Built-in
memory
USB
device
For built-in
memory
For USB
device
In the programmed order.
In the reverse order.
2 sec.
PROGRAM RANDOM
GROUP
RANDOM*
GROUP*
Canceled
UX-DM8[U].book Page 16 Monday, June 4, 2007 8:20 PM