13
To scan ensembles
With the ensemble scanning function, the System scans the
band III to pick out receivable ensembles.
• When you change the source to DAB for the first time after
plugging in the System, it automatically performs the
scanning.
To perform the ensemble scanning manually
After moving the System or adjusting the antenna position,
perform the scanning manually.
When the scanning is complete, the System starts playing the
primary service of the lowest-frequency ensemble found.
To select a service from all ensembles
You can select a service from all ensembles regardless of the
signal strength.
The frequency changes every second, going through all
DAB ensembles.
Press and hold either button until you reach the desired
ensemble.
Presetting Services
You can preset 30 services in memory.
1 Tune in to an ensemble, then select a service you want
to preset.
2 Activate the preset number entry mode.
3 Select a preset number for the service you want to
store.
To tune in to a preset service
2 sec.
2 sec.
Remote
ONLY
B
AND
Increases the
preset numbers.
Decreases the
preset numbers.
B
AND
DAB
B
AND
DAB
Increases the preset numbers.
Decreases the preset numbers.
You can also use the number buttons.
• To enter preset number 5,
press 5.
• To enter preset number 15,
press 10 → 1 → 5.
• To enter preset number 20,
press 10 → 2 → 0.
=
>
=
>
UX-G250D[B].book Page 13 Friday, June 6, 2008 10:02 PM
To Next Page
Loading...
Need help?
General
