16
Next program step is indicated.
For MP3/WMA disc and USB mass storage class device
1 Select a group.
• To select groups, you can also use the GROUP
5/K.
2 Select a track.
Next program step is indicated.
4 Repeat step 3 to program other tracks.
5 Start playback.
The tracks you have selected are played back in the order
you have programmed.
• You cannot select the track with the number buttons during
Program Play.
To check the programmed contents
While the PROGRAM indicator is lit on the display and
playback is stopped...
To modify the program
While the PROGRAM indicator is lit on the display and
playback is stopped...
To skip a track: To pause: To stop:
To release, press
again.
CD
PROGRAM
MP3
PROGRAM
Program step
Group number
MP3
PROGRAM
Track number
MP3
PROGRAM
or
or
To edit:
1 Press PROGRAM repeatedly until the program step
you want to edit is displayed.
2 Repeat step 3 on pages 15 and 16.
To add tracks in the program:
1 Press PROGRAM repeatedly until “00” or “G00” is
displayed.
2 Repeat step 3 on pages 15 and 16.
To erase entire program:
The PROGRAM indicator goes off.
• Program contents are also erased by the following
operations:
– When you open the CD door or disconnect USB mass
storage class device.
– When you change to other sources.
– When you turn off the System.
UX-G250D[B].book Page 16 Friday, June 6, 2008 10:02 PM
To Next Page
Loading...
Need help?
General
