JVC UX-GD6M - Page 12

1-12 (No.MB408)
3.1.6 Removing the rear panel
(See Fig.13)
• Remove the metal cover and rear cover.
(1) Remove the fifteen screws G attaching the rear panel.
(2) Remove the two screws H attaching the rear panel. [Only
for US version]
(3) Release the joint sections e and remove the rear panel.
Fig.13
3.1.7 Removing the video board
(See Fig.14)
• Remove the metal cover, rear cover, cassette chassis assem-
bly, tuner and rear panel.
Reference:
Disconnect the card wire from the connector CN1
on the tuner
as required.
(1) From the top side of the main body, disconnect the card
wire from connector CN303
on the amplifier board.
(2) Disconnect the card wire from the connector CN710
on the
micom board.
(3) Take out the video board from the main body.
Fig.14
G
G
G
e
e
Rear panel
H
CN303
CN710
Micom board
Amplifier board
Video board