JVC UX-GD6M - Page 15

(No.MB408)1-15
3.1.10 Removing the speaker board
(See Fig.18)
• Remove the metal cover, rear cover and rear panel.
(1) From the right side of the main body, disconnect the con-
nector CN310
on the speaker board toward this side.
(2) Remove the speaker board from the joint section h in the
direction of the arrow.
Fig.18
3.1.11 Removing the amplifier board
(See Fig.19)
• Remove the metal cover, front panel assembly, rear cover,
cassette chassis assembly, tuner, rear panel, video board, AC
board, micom board and speaker board.
(1) From the top side of the main body, disconnect the card
wires from the connectors (CN304
, CN307) on the amplifi-
er board.
(2) Disconnect the parallel wire from the connector CN308 on
the amplifier board.
(3) Remove the wire holders fixing the wires and remove the
wires from the slot j.
Reference:
When connecting the wires, pass them through the slot j
of the amplifier board and fix them with the wire holders
as before.
(4) Remove the two screws Q and remove the amplifier board.
Fig.19
CN310
Speaker board
h
CN308
Amplifier board
Q
CN307
CN304
Q
Wire holders
j