1-14 (No.MB408)
3.1.9 Removing the micom board
(See Figs.16 and 17)
• Remove the metal cover, front panel assembly, rear cover and
cassette chassis assembly.
(1) From the back side of the main body, remove the two
screws N attaching the micom board to the rear panel. (See
Fig.16.)
(2) From the right side of the main body, remove the screw P
attaching the micom board. (See Fig.17.)
(3) Disconnect the connectors (CN200
, CN210) on the micom
board toward this side. (See Fig.17.)
(4) From the forward side of the micom board, disconnect the
card wires from the connectors (CN220
, CN700, CN710)
on the micom board. (See Fig.17.)
(5) Disconnect the wire from the connector CN230
on the mi-
com board. (See Fig.17.)
Reference:
When connecting the wire to the connector CN230
, fix it
with the wire holder as before. (See Fig.17.)
(6) Take out the micom board from the main body.
Reference:
When attaching the micom board, insert the edge of the
micom board in the slot g of the rear panel as before.
(See Fig.17.)
Fig.16
Fig.17
N
Micom board
Rear panel
Rear panel
CN700
CN230
CN710
CN210
CN200
CN220
P
Micom board
Micom board
g
CN230
Wire holder
To Next Page
Loading...
