(No.MB408)1-17
3.1.14 Removing the power transformer
(See Fig.22)
• Remove the metal cover, front panel assembly, rear cover,
cassette chassis assembly, tuner, rear panel, video board, AC
board, micom board, speaker board and amplifier board.
(1) Remove the wire holder fixing the wire.
Reference:
When connecting the wires, fix it with the wire holder as
before.
(2) Remove the four screws S and take out the power trans-
former.
3.1.15 Removing the DVD mechanism assembly
(See Figs.22 and 23)
• Remove the metal cover, front panel assembly, rear cover,
cassette chassis assembly, tuner, rear panel, video board, AC
board, micom board, speaker board and amplifier board.
(1) Remove the wire holder fixing the wire. (See Fig.22.)
Reference:
When connecting the wires, fix it with the wire holder as
before. (See Fig.22.)
(2) Remove the three screws T attaching the shield case on
the bottom chassis. (See Fig.22.)
(3) Remove the wires from the sections (k, m) of the wire hold-
er on the DVD mechanism assembly. (See Fig.23.)
Reference:
After attaching the DVD mechanism assembly, pass the
wires through the sections (k, m) on the DVD mecha-
nism assembly as before. (See Fig.23.)
(4) Remove the screw U attaching the DVD mechanism as-
sembly and take out the DVD mechanism assembly from
the bottom chassis. (See Fig.23.)
Reference:
When the resolution of DVD mechanism assembly is done se-
quentially, remove the wire holder on the DVD mechanism as-
sembly. (See Fig.23.)
Fig.22
Fig.23
Shield case
Power transformer
T
T
S
S
Bottom chassis
Wire holde
DVD mechanism assembly
U
Bottom chassis
mk
Wire holder
To Next Page
Loading...
