1-18 (No.MB408)
3.1.16 Removing the AUX board and headphone board
(See Fig.24)
• Remove the metal cover, front panel assembly, rear cover,
cassette chassis assembly, tuner, rear panel, video board, AC
board, micom board, speaker board and amplifier board.
(1) Remove the screw V attaching the AUX board on the bot-
tom chassis.
(2) Take out the AUX board from the bottom chassis.
(3) Remove the screw V attaching the headphone board on
the bottom chassis.
(4) Take out the headphone board from the bottom chassis.
Fig.24
3.1.17 Removing the cassette mechanism assembly
(See Fig.25)
• Remove the metal cover, rear cover and cassette chassis as-
sembly.
(1) From the bottom side of the cassette chassis assembly,
disconnect the card wires from the connectors (CN33
,
CN34) on the cassette mechanism assembly.
(2) Remove the four screws W and screw W' attaching the
cassette mechanism assembly.
Reference:
When attaching the screw W', attach the support board
with it.
(3) Take out the cassette mechanism assembly from the cas-
sette chassis assembly.
Reference:
• Remove the head shield from the cassette mechanism as-
sembly as required.
• When removing the head shield, remove the two screws X
after removing the soldered section n of the head shield.
3.1.18 Removing the microphone board
(See Fig.25)
• Remove the metal cover, rear cover and cassette chassis as-
sembly.
(1) From the bottom side of the cassette chassis assembly,
disconnect the card wire from the connector CN601
on the
microphone board.
(2) Remove the two screws Y and take out the microphone
board with the support board.
(3) Remove the support board from the microphone board.
Fig.25
UX board
V
V
Headphone board
Y
W
XX
W
W
W'
Support board
Cassette mechanism assembly
Head shield
n
Microphone board
Support board
CN601
CN33
CN34
To Next Page
Loading...
