Additional information
Additional
information
62
XV-N5SL/LET0204-001A/English
PICTURE
Symptom Possible cause Remedy
No picture is displayed on the monitor. Connection of video cable is incorrect. Connect the cable correctly.
Input selection of TV is incorrect. Select correctly.
Disc is not playable. Use a playable disc (see page 4).
No picture is displayed on the monitor or
the screen is blurred or divided into two
parts.
The unit is in the progressive scanning
mode (i.e. the PROGRESSIVE indicator is
lit) through it is connected to a TV via the
VIDEO or S-VIDEO jack.
Set the Scan mode selector on the rear
panel to "480i," or set it to "REMOTE" and
make the Progressive scanning mode
inactive by using the VFP - PROGRESSIVE
SCAN button (see pages 7 and 8).
The picture is noisy or blurred. The unit is connected to a VCR directly and
the copyguard function is activated.
Connect the unit so that the picture signal
flows directly to the TV.
With some discs, the picture may be
blurred when
"PROGRESSIVE MODE" is
set to
"FILM" or "AUTO."
Set "PROGRESSIVE MODE" to "VIDEO"
(see page 51).
The picture does not fit the television
screen.
MONITOR TYPE is not set correctly. Select monitor type correctly (see page 51).
TV settings are incorrect. Set the television correctly.
The upper and lower parts of the
preference display are cut off when using
wide-aspect TV.
It depends on the setting on the TV. Adjust the TV screen using the controls on
the TV.
AUDIO
Symptom Possible cause Remedy
No audio is reproduced. Connection is incorrect. Check the connection.
Input selection of amplifier is incorrect. Select correctly.
No audio is reproduced when playing back
a DVD disc recorded with high sampling
frequency (88.2 kHz or more) linear PCM
audio using the DIGITAL OUT jack.
Audio signal is not emitted from the unit’s
DIGITAL OUT (see page 53).
Use AUDIO OUT when playing back such
discs.
Audio volume is low when playing back
with the unit, compared with the TV or
VCR.
The audio level recorded on a DVD VIDEO
is lower compared with a TV broadcast.
Turn up the volume of the TV or amplifier/
receiver.
Remember to turn the volume back down
before switching back to a TV broadcast to
prevent a sudden burst of high-volume
sound.
Sound is distorted or noise is generated. Disc is dirty. Wipe the disc surface (see page 5).
XV-N5SL(J).book Page 62 Wednesday, July 24, 2002 1:04 PM
To Next Page
Loading...
Need help?
General
