JVC XV-S402SL - Page 10

XV-S300BK/XV-S332SL/XV-S402SL/XV-S403SG
10
2.2.3 Removing the traverse mechanism
assembly (See Fig.2-12 and 2-13)
• Prior to performing the following procedure, remove the
clamper assembly and the tray.
(1) Remove the four screws B attaching the traverse mecha-
nism assembly.
ATTENTION:
Before reattaching the traverse mechanism assembly,
pass the card wire extending from the spindle motor
board through the notch d of the elevator.
Fig.2-12
Fig.2-13
2.2.4 Removing the elevator (See Fig.2-14)
• Prior to performing the following procedure, remove
the clamper assembly, the tray and the traverse
mechanism assembly.
(1) Extend each bar e inside of the loading base
outward and detach the elevator shaft.
ATTENTION:
When reattaching, first fit the two
shafts on the front of the elevator to
the slots f of the slide cam.
Fig.2-14
BB
B
BB
B
Traverse mechanism
assembly
B
BB
Traverse mechanism assembly
Elevator
Notch d
Elevator
Elevator
Elevato
r
e
e
Loading base
Elevator
Shafts
Slide cam
Slots f