K-Rain KRX8 - Holman Home Automations; Test Function

31 of 40
Additional Notes
Holman Home Automations
 STARTS run from a
Holman Home automation
will behave the same as
a manually run START
 WATERING DELAYS only
effect schedules from
the KRX8 interface–
STARTS running from
automations will ignore
WATERING DELAYS
 To exclude ZONES using
the WATERING DELAY
function, this will need
to be set using two
automations–for example:
L If the time is 1:00 am and
WATERINGDELAY is ON,
then water ZONE 1 and,
if the time is 1:00 am and
WATERING DELAY is OFF,
then water ZONE 1, 2 and 3
Test Function
1. To test the KRX8
system, turn the
MAINDIAL to TEST
2. Press START on
board the controller
 Activated ZONES in
any START will run for
2minutes, sequentially
from ZONE 1 to 8
 If no ZONES are activated
in any STARTS, the test
function will not run
 To skip a ZONE during the
process, press START
on board the controller