Operating Manual BRAVO II
8
BELT TENSION AND REPLACEMENT
If the belt should come loose, remove the shield, and loosen the four nuts (*) holding the motor to the
base (fig. 11). Adjust the position of the motor until the belt tension is tight (about 1/2” play in the
belt).The belt is replaced the same way.
Fig. 11
REPLACING THE TRACER POINT
1) Completely unscrew the tracer point knob (R) and remove it as shown in fig. 12.
2) Completely unscrew (R2), loosen the dowl (M) and remove the tracer point (D) as shown in fig. 13.
3) Replace the tracer point, carrying out the instructions described in #2 in reverse order.
4) Replace the knob (R) and tighten. Re-set the machine following the instructions on page 3.
Fig. 12
Fig. 13
*
R
M
D
R2 D
M
To Next Page
Loading...