Operating Manual BRAVO II
4
SPACE SETTING
1) Place the set up blanks in the jaws as shown in fig. 2-A using the key gauge (N) with the grooves
facing the cutter.
2) Make sure to leave the main switch off. Release the carriage and position the blanks so that the
grooves come in contact with the cutter and tracer point. Turn the cutter a complete revolution by
hand in the opposite direction of cutting. The cutter should skim both sides of the groove, in other
words the cutter should fit squarely in the groove.
3) If the cutter skims only one side of the blank, loosen screw (M1) and move the tracer point support
(D1) sideways. When the cutter skims both sides of the blank, tighten the screw (M1).
4) Use the carriage handle (Z) to return the carriage to the neutral position. The carriage will
automatically lock in position. The machine is now ready for operation.
IMPORTANT:
when the set up blanks have been used a number of times, they must be replaced.
Two identical blanks can be used as an alternative.
Fig. 2
K
M
U
T
Z
K
N
DD1
R1
R
M1
A
B
To Next Page
Loading...