Need help?Do you have a question about the Kaisai KHC-06RY1 and is the answer not in the manual?
Explains DANGER, WARNING, CAUTION, and NOTE symbols and their meanings.
Lists general precautions for installation, handling, and electrical safety.
Describes unit uses, controller, backup heater, and operating ranges.
Lists items included with the unit and those available from the supplier.
Details the refrigerant type, GWP, and factory-charged volume.
Specifies conditions for selecting a suitable location for the unit.
Provides guidance for installing the unit in various climate conditions.
Shows dimensions, clearances, and foundation requirements for installation.
Specifies clearances needed for maintenance access around the unit.
Illustrates typical system configurations for heating and hot water.
Diagrams a cascade system setup for increased capacity.
Describes the key components within the hydraulic module.
Details the arrangement of control boards within the electronic control box.
Outlines checks for the water circuit and piping connection requirements.
Provides wiring guidelines and essential safety precautions for electrical work.
Explains how to configure unit settings using DIP switches.
Covers initial start-up procedures and accessing field settings via the interface.
Lists essential checks and guides on performing manual test runs.
Details annual checks and maintenance tasks.
Lists possible issues, corrective actions, and error code identification.
Provides general and electrical data including dimensions, weight, and power requirements.
Outlines safety precautions, leak detection, and refrigerant handling for servicing.
Illustrates the refrigerant flow and provides installation notes for E-heating tape.
General| Type | Heat Pump |
|---|---|
| Cooling Capacity | 6, 000 BTU/h |
| Heating Capacity | 6, 000 BTU/h |
| EER | 10.5 |
| Refrigerant Type | R410A |
| Power Supply | 220-240V/50Hz/1Ph |
| Compressor Type | Rotary |
| Noise Level (Outdoor) | 52 dB |
To Next Page
