Kaiser Baas GAMMA - Drone;Transmitter Binding; Drone Calibration

EN
GAMMA DRONE | User Guide
16
DRONE/TRANSMITTER BINDING
To operate your Drone, you must rst bind the Drone to your Transmitter before every
ight.
Ensure your Drone and Transmitter are fully charged and follow these steps in order:
1. Turn on your Drone by holding the power button for 1.5 seconds.
2. The Drone lights will ash indicating it is ready to bind to a Transmitter.
3. Turn on the Transmitter.
4. Using the Left Throttle/Yaw Stick move it to the maximum UP position and return it
back to the zero position.
Note: you must complete this process within 5 seconds of powering on the
Transmitter or you will have to restart the process.
5. The Drone LED lights will stop ashing indicating the Drone is now paired to the
Transmitter.
DRONE CALIBRATION
Before every ight it is important to calibrate your Drone.
Calibration ensures the Gyroscopes are reset and the Drones Direction/Heading is xed.
Always calibrate with the Drone and the Pilot facing the same direction.
Calibration:
1. Place the Drone on level ground facing the same direction as the pilot.
2. Push the Left Throttle/Yaw Stick and the Right Pitch/Roll Stick to the bottom left and
hold for 2 seconds until you see the LED indicator lights on the drone start to ash
rapidly.
3. Release the sticks and wait for the drone LEDs to stop ashing.
4. The Drone LEDs will stop ashing indicating that the calibration has been completed.
1 2