Kaiser Baas GAMMA - Faq

EN
GAMMA DRONE | User Guide
29
FAQ
Q1. The Drone LED lights are ashing. What does this mean?
A1. The Drone is not paired with a Transmitter. Refer to the Drone Setup/Installation
section.
A2. The Drone has insucient battery power. Please charge the Drone battery.
Q2. The Drone’s Rotor Blades spin but the Drone does not take-o?
A1. Insucient Battery Power. If the Drone LEDs are flashing and the Drone Rotor blades
are spinning without any lift, recharge the Drone battery.
A2. The Rotor Blades are distorted. Replace them with only ocial Kaiser Baas
replacement blades.
Q3. Why is the Drone is shaking and not stable in ight?
A1. Please check to ensure the Rotor Blades are not damaged. Refer to the maintenance
guide on Rotor Blade care.
A2. Check that all the motors are spinning. Refer to the maintenance guide for more
information.
Q4. My Drone keeps tipping when I take-o!
A1. It is often dicult for new Pilots to get used to the take-o procedure. To take-o
without tipping, give the Drone a smooth lift of power with the Throttle, rather than a
quick movement. Once in the air, keep the Drone level using the Right Stick (Elevator/
Aileron).
Q5. The Drone is out of control and is dicult to y. How can I make it easier?
A1. Prior to every flight we recommend you calibrate the Drone. To calibrate push the
Left Throttle/Yaw Stick and the Right Pitch/Roll Stick to the bottom left and hold for
2 seconds until you see the LED indicator lights on the drone start to flash rapidly. The
Drone LEDS will stop flashing when calibration is complete.