Photo Mode
To enter Photo Mode, click the Power/Toggle button once on the front of the
camera.
Click the Record/Confirm button to take a photo.
When capturing a photo, the RED photo LED on the front of the camera and the
blue power LED on the back of the camera will flash once.
There are 3 modes to capture photos.
Photo Settings
Photo Resolution.
Timer Mode
When this mode is enabled, it lets you set intervals for when a single photo is taken
after clicking the Record/Confirm button.
The camera will countdown with a beep.
3/5/10/20 second intervals are available.
Auto Mode
Auto photo mode allows you to shoot a continuous sequence of photos. This mode
is activated by clicking the Record/Confirm button and will shoot automatically until
stopped by pressing the Record/Confirm button again.
Shoot in this mode with the following intervals 3/10/15/20/30 seconds.
Photo Burst Mode
Photo burst lets you capture photos in a rapid fast firing sequence.
You can set the following intervals 3/5/10 P/S (photos/second)
Note: Shooting in higher intervals requires some time to save the images to the
memory card. The BLUE power LED will flash while saving.
To Next Page
Loading...
