BATTERY GUIDE MAINTENANCE
15 - ENG 16 - ENG
Only use KB ocial batteries with this product.
Never use any third party or unknown accesso-
ries or batteries.
To charge the camera:
1. Insert the battery into the camera
2. Connect the USB Charging Cable to the
Mini USB port located on the camera.
3. Connect the USB Charging Cable to a
computer or wall charger.
WARNING!: If using a wall charger, ensure that
it is a certied product for your region. AC
Input: 100-240VAC 50/60Hz. DC Output: 5VDC
0.5A/1A. Only use a USB charger with suitable
approval and certication. If you do not know
the output voltage/current of the charger use a
computer to charge the battery. Do not charge
in conditions outside of the 10°C-45°C range.
4. The camera status LED will be RED whilst
charging.
Once charging is complete the status LED
light will switch OFF.
5. A full charge cycle will take approximately
2.5 hours by 0.5A/1A charger.
Battery Tips
To maximise battery life:
● Turn o WiFi.
● Turn on the Screen O function.
● Capture at a lower Video Resolution and
frame rate. Higher resolutions and frame
rates impact battery performance.
● Avoid exposing the camera and battery to
very cold or hot temperatures. Cold or hot
temperatures may temporarily aect the
battery life and cause the camera to stop
working.
● Only ever charge the camera with a
compliant wall charger marked 5V/1A.
Adhere to these guidelines to ensure maximum
performance and longevity.
● Never use the camera in water without
the waterproof case. The camera is not
waterproof without the case.
● If camera has been used in salt water
ALWAYS rinse the waterproof case in fresh
water to prevent corrosion.
● Regularly check the seals for debris or
dust on the door of the waterproof case to
prevent water, sand and dirt ingress.
● Never handle the camera, battery or
MicroSD Card with wet hands or in wet
conditions.
● Clean the camera lens and waterproof
case lens with a soft micro bre towel to
reduce any blurry footage due to grease/
ngerprints.
To Next Page
Loading...
