Kaiweets HT206D - Page 5

+ Do not apply more than the rated voltage, as marked on the Meter, between the terminals
or between any terminal and earth ground.
+ Remove test leads from the Meter before opening the Meter case.
« Never operate the Meter with the back cover removed or the case open.
+ Never remove the back cover or open the case of an instrument without first removing
the test leads or the jaws from a live conductor.
+ Use caution when working with voltages above 30 V ac RMS, 42 V ac peak, or 60 V dc.
These voltages pose a shock hazard.
« Do not attempt to measure any voltage that might exceed the maximum range of the
Meter- 600 V RMS and 1 kHz or 600 V dc.
« Do not operate the Meter around explosive gas, vapor, or dust.
+ When using probes, keep fingers behind the finger guards.
« When making electrical connections, connect the common test lead before connecting
the live test lead; when disconnecting, disconnect the live test lead before disconnecting
the common test lead.
« Disconnect circuit power and discharge all high-voltage capacitors before testing
resistance, continuity, or diodes.
« Check the operation of the meter at a known source before and after use.