Kaiweets HT208A - Page 22

Continuity test e1)
1. Turn the rotary switch to 9,,'4"('. and press the “FUNC." key until 01)) appears on the
display. The continuity test is now active.
2. Plug the black test lead into the COM socket and the red test lead into the INPUT
socket.
3. Connect the probes to the circuit or component under test.
4. If the resistance is <30 Q, the LED indicator light is on at the same time, the
resistance value will be displayed.
Note: When measuring resistance on a circuit, the measured value can be influenced
by other circuits.
Test Voltage Approx. 1V
Overload protection: 250V