Kaiweets KM601s - Resistance Measurement

3. Insert the red probe into ‘INPUT® jack and the black probe into the ‘COM’ jack.
4. Touch the meter probe to both ends of the power supply under test.
5. When measuring AC voltage, the frequency is displayed at the same time otherwise the
ambient temperature is displayed.
6. Read the measurement results from the display.
NOTE:
1. When measuring AC voltage, the frequency will be displayed.
2. When measuring DC voltage, the ambient temperature will be displayed on the screen.
3. Do not use the AC voltage test function to test DC voltage and vice versa.
4. Do not measure voltage exceeding 1000V DC or 750V AC to avoid damage to the meter.
Resistance measurement
1. Press ‘A9 button to select ‘2 gear. ¢ Q signal will be displayed on the screen, indicating
the resistance measurement.
2. Insert the red probe into ‘INPUT’ jack and the black probe into the ‘COM’ jack.
3. Touch the meter probe to both ends of the resistance under test.
4. Read the measurement results from the display.
NOTE:
1. Do not change the resistance while taking measurements.
2. Do not test parallel circuits. The accuracy of the measurement will be affected, and the results
1