Kaiweets KM602 - Page 8

Probe terminal prompt
When changing gears, the corresponding input jack light wil flash 5 times, so convenient for you to
insert the test leads into the correct jack.
Automatic recognition of current measurement
When the current Ajack is inserted, the meter jumps to "A=" gear and enters current measurement
automatically, and gear switching is not allowed.
When manually switched to current gear with no lead in Ajack, LCD displays "LEA" and no further
measurement taken.
Automatic turn off
Press the " ()" button to power on, with automatic turn-off function by default and "(%" symbol
displayed on LCD. After 15 minutes of inactivity, the device will tum off automatically to save battery
energy.
When the device is tuned off, pressing and holding the (&) " and " ()" buttons at the same time, then
power on the device to cancel the automatic turn-off function. The "(% " symbol is not displayed, and
an audible prompt when the automatic tum-off function is canceled.
Charging mode
When enter the charging mode, do not take measurements.
1. CHARGE symbol is displayed on screen, analog bar scrolling with batter level percentage
displayed.