Kaixin BVT02 - Chapter Six System Installation and Check

                                                                        
 >)>
6.1 System placement
# 


# 
83 "(

6.2 Install/Remove the battery
6(!$ $
8O)$= ($ $8O)
$( 
       
Battery
the lower cover of
the main unit
 
 
6.3 Connection to power
1. Connect to the power adapter
1?2$($
2. Connect to the main power supply
1$4+5$$$(
>>$1$
 $$$


6.4 Ultrasonic probe check before and after operation
       !    
   +(   ( ( (       (  

6.5 Main unit check before and after operation
6.5.1 Inspection before start-up
2$%
("

Warning: 
1. Adapter has no switch. APPLIANCE COUPLER or MAINS PLUG is used as the intended
disconnection device from the supply mains. Do not position the EQUIPMENT the place
where it is difficult to operate the disconnection device.
2. AC/DC adapter is as a part of the equipment, please only use the AC/DC adapter provided
by Kaixin Company.
3. To avoid damaging power adapter or harming people by unexpected fallen, make sure the
power adapter is placed on the leveled desk.
4. The operator must not touch signal input/output and patient simultaneously.
Warning:
Do not short
-
circuit the b
attery terminals.
8O)
$
8O)
$