8
"The red light is flashing fast and continuously" icon on the App interface, click the
"Next" button, and wait for the network configuration to be completed.
5. If the indicator is flashing slowly at a frequency of on for 0.2 seconds and off for 2
seconds (configure network by AP), select the "The red light is flashing slowly and
intermittently" icon on the App interface, click the "Next" button, and complete the
network configuration according to the interface prompts.
6. After the connection is successful, the App will prompt that the connection is successful.
At this time, the status indicator (red) is on, indicating that dosing pump has been
connected to the cloud, and the user has also completed the binding with dosing pump.
Bind F4 PRO
There are two ways for the user to bind the dosing pump. The first way is to bind the dosing
pump through the method above; the second way is that the dosing pump has been connected
to the cloud through the wireless router, and the mobile phone can be connected to the
wireless under the router, the app will display the locally available dosing pump. The user can
directly click the corresponding "Bind" button on the right side to bind the dosing pump in the
list of scanned dosing pumps.
Unbind F4 PRO
Long press the corresponding device icon on the device list page, the "Remove" icon will pop
up at the bottom, and click the "Remove" icon to unbind.
Notes
Please use the product's own power adapter and work in the specified working
environment.
This product only supports 2.4G Wi-Fi and does not support 5G Wi-Fi.
The dosing pump should be placed in a reasonable position to ensure that the height
difference between the inlet and the outlet is within 0.5 m.
The connection pipe for liquid inlet should be as short as possible, and the outlet
connection pipe should be suspended above the container.
Please check carefully that the inlet and outlet connections are in the correct direction.
To Next Page
Loading...
