User manual wM-Bus Dongle SW Tool
1
Overview
This document describes how to use the Kamstrup wM-Bus Dongle SW Tool to set up a wM-Bus
dongle to communicate with a wireless M-Bus meter. The meter can be a Kamstrup heat or water
meter or other wireless M-Bus meters using C-mode communication.
5512-1057 GB / 12.2011 / A1
Figure 1
This Tool is used for setting up the parameters in the dongle to enable it to communicate with the
selected meter devices. The Tool communicates with the wM-Bus dongle either through wired
connection or wirelessly through a Kamstrup wM-Bus Dongle USB Tool connected to a PC.
1
To Next Page
Loading...