Kangaroo pet - Language Selection

3. circuit description (cont.)
E
Sage”
language selection
Selection of the language used for the pump display is determined by the position of
the rotary switch mounted on the pump circuit board. This rotary switch may be rotated
by placing the tip of a small flat-bladed screwdriver into the switch access hole inside
the battery compartment. This access hole is located next to the right-hand screw hole
inside
the battery compartment. The chart below shows the switch settings by country
and the language display text. The language display text may be accessed by pressing
the CLR key while simultaneously turning the pump on. Note that the switch setting
numbers increase as the switch is rotated in a clockwise direction. Switch position 0 is
at the top of the switch.
SWITCH DISPLAY
POSITION # LANGUAGE TEXT
0 English or Japanese CUS
(U.S./Canada)
1 English EnA
(UK/Australia)
2 German GEr
3 Dutch nEth
4 French FrA
5 Halian itA
6 Swedish Sdn
7 Spanish ESP
8 English or Japanese CUS
(U.S./Canada)
9 English EnA
(UK/Australia)