Kangaroo pet - Troubleshooting Guide

7. troubleshooting guide
Listed below are some of the probable causes of alarm conditions and
their corrections.
Symptom ; Probable Cause | Corrections
No Set Pump set has Check to make sure that only Kangaroo Pump Set
Alarm been improperly | has been placed onto the pump.
(no SEt) | placed onto Check to make sure that the pump set has been
pump. properly positioned on the pump.
Flow Error | Feeding Refill feeding container. if feeding set has been
Alarm container is in use for 24 hours, replace.
(FLO Err) | empty.
Feeding tube or | Locate point of occlusion and correct. Note: occlusion
feeding set may occur upstream or downstream from pump.
tubing is © Feeding Container
occluded. * Feeding Pump Set (control clamp closed)
* Feeding Tube—feeding tube should be checked for
obstruction.
Drip chamber Check to make sure formula is not preventing drop
walls are coated | detector from proper operation. if formula cannot
with feeding be removed from inside walls of chamber via
formula. chamber manipulation, replace feeding set.
Sensor in upper | Check to make sure black surface of drip chamber
drip chamber guide is free of dried formula. Remove any deposits
guide is blocked. | by using a cotton swab dampened with warm soapy
water or isopropyl alcohol.
Low Battery has been | Insert pump into charger base and plug power cord
Battery run down. into wall outlet.
Alarm
(LO bAt)
Hold Error | Pump has been | Press START/HOLD to silence alarm, then press
Alarm left in the hold START/HOLD again to restore flashing rate display,
(HLd Err) | mode for over and press START /HOLD again to restart pump.
25 minutes.
System Problem with Return pump for technical service.
Error rotor, rotor
Alarm position sensing
(SYS Err) | or other rotor
circuit problem.
Internal Problem with Return pump for technical service.
Circuit internal pump -
Problem circuitry.
Alarm
(8888)
Dose Preset dose has | Repeat the dose amount by clearing the volume
Delivered | been delivered delivered; OR cancel the dose feature by pressing
Alarm to patient. DOSE and CLR; OR to feed additional volume,
(dOSE increase the dose amount by pressing DOSE, then
dEL) A until new dose is displayed; OR turn the pump off.
25