KSTB2020
User Guide
9
TV / Remote Pairing
By default, the remote controls the volume and power on the STB. To pair the
remote to the TV such that remote Master Power key presses adjust power and
volume on the TV directly follow the instructions below:
• Press and hold the key until the remote LED turns green
• Enter the 5-digit code as shown in Appendix A
• Successful pairing is indicated by two green blinks of the LED
• Unsuccessful pairing is indicated by two red blinks of the LED
Audio System - Sound Bar / Remote Pairing
By default, the remote controls the volume and power on the STB. To pair the
remote to the sound bar, such that remote Master Power key presses adjust volume
on the Sound Bar directly, follow the instructions below:
• Press and hold the key until the remote LED turns green
• Enter the 5-digit code as shown in Appendix B
• Successful pairing is indicated by two green blinks of the LED
• Unsuccessful pairing is indicated by two red blinks of the LED
Remote Behavior
If the remote has been paired to the TV and Audio Systems as described in above,
the remote's TV power button ( ) will control the TV power and Audio System
power states only.
This will not aect the powered state of the STB. The remote's power button
( ) will control the TV power as well as the STB and audio system power states
if remote has been fully paired with TV and Audio system.
The remote's power button ( ) may be used in two ways while system is fully
powered on:
Short Press: Will turn o TV and Audio sub-system and put the STB into a
standby mode.
Long Press: User will be prompted if they want STB to be powered down
(non-standby) mode. If OK is selected the TV, Audio system, and STB will all be
powered down. The STB will be fully powered down and not be in standby mode.
Set
TV
Set
To Next Page
Loading...
Need help?
General
