Rear Panel
Note! : The design of the Rear Panel may be changed without any notice in advance.
1. POWER SUPPLY 90 ~ 250V AC, 50/60Hz.
2. S/PDIF Output for connection to a digital amplifier.
3. SCART FOR VCR Connect this port to the VCR via SCART cable.
4. SCART FOR TV Connect this port to the TV via SCART cable.
5. VIDEO Video connection port to the TV or other equipment.
6. AUDIO Audio connection port to the TV or other equipment.
7. N/C No Connection.
8. RF LOOP IN To connect to a general aerial antenna and cable jacks to a RF
input jack on the STB.
9. TV OUT To connect a TV via a coaxial cable.
10. RS-232 To connect to a personal computer for software upgrade.
11. LNB To connect to a satellite antenna and cable jacks.
12. LOOP THROUGH Used to connect a RF signal from the STB to either the RF
input jack on your television or to the STB.
13. ANTENNA To connect to a digital terrestrial antenna input.
14. RF LOOP OUT Used to connect a RF signal from the Receiver to either the RF
input jack on your television or to the Receiver (RF Loop In).
To Next Page
Loading...
