10
OPERATING INSTRUCTIONS
Working in Automatic mode (self-leveling):
In automatic mode the laser level will level itself in the
range of ± 3° and will project horizontally or vertically or
both lines simultaneously.
1. Remove the laser from the case and place it on a solid
at Vibration free surface or on a tripod.
2. Push the locking switch #1 forward to the ON position.
The laser level will generate the crossed horizontal and
vertical lines and the green LED will light up.
3. Choose the beams that you want to work with by
pushing the V/H operation push button
4. If the initial slope of the laser is beyond ± 3° the laser
lines will ash. In this case reposition the laser on a
more leveled surface.
5. Before moving the laser level switch the locking switch
#1 backward to the OFF position, this will lock the
pendulum and protect your laser.
To Next Page
Loading...