Why is my Kärcher Scrubber not cleaning well?
If your Kärcher Scrubber isn't delivering sufficient cleaning results, you should: * Check the brush roller for any foreign objects. * Check or replace the brush roller. * Check or replace the toothed belt.
What to do if the brush roller on my Kärcher Scrubber isn't rotating?
If the brush roller on your Kärcher Scrubber isn't rotating, consider these steps: * Check the brush roller for any foreign objects. * Check if the coupling is disengaged. * Check or replace the toothed belt. * Check or replace the suction turbine. * Check the brush roller intake. * Ensure the cable behind the tanks is routed flat and the included cover is attached (current model only).
Why is the fresh water reservoir of my Kärcher Scrubber dripping after refilling?
If the fresh water reservoir of your Kärcher Scrubber drips after refilling, check and clean the water outlet valves on the fresh water reservoir.
Why is suction too low on my Kärcher Cleaning Equipment?
If the suction is too low on your Kärcher Cleaning Equipment, consider these potential causes and solutions: * The dirt water reservoir may be full; empty it. * The wastewater reservoir might not be correctly positioned; check and correct its positioning. * Seals between the wastewater reservoir and cover may be damaged or loose; clean, check, or replace them and ensure tightness. * Check the seals between the lid of the waste water reservoir and the appliance. * The vacuum bar may be incorrectly positioned; check and lock it into the correct position. * The vacuum bar could be worn out; check it for wear and tear and replace it if necessary. * The suction pipe connection may be loose; check that the suction hose and pipe are properly connected, and reconnect if needed. * ...
Mandatory step before appliance operation. Ensures user awareness of all operating guidelines.
Details essential grounding procedures and potential risks of improper connection.
Defines the operator's duty to be familiar with the unit and follow safety rules.
Covers general operation rules like starting position, safe distance, and modifications.
Provides guidelines for safe travel, including yielding, speed, and crossing obstacles.
Instructions for reporting unsafe conditions and prohibiting unauthorized repairs or adjustments.
Guidelines for hazard prevention and proper maintenance procedures by trained personnel.
Covers unit cleanliness, approved cleaning agents, and nameplate visibility.
Describes the appliance's purpose for wet cleaning of level floors and its capacity.
Specifies authorized uses, temperature ranges, and prohibited applications.
Recycling packaging materials and proper disposal of old units containing valuable materials.
Lists and describes all control elements of the appliance, referencing Figure 1.
Lists recommended detergents for different cleaning applications and cautions about their use.
Detailed steps for cleaning normal and severe soiling, including suction bar operation.
Specific instructions for vacuuming corners using the suction tube on the Adv model.
Steps to complete cleaning, including turning off switches and disconnecting power.
Procedures for emptying both waste and fresh water reservoirs, including warnings.
Guidelines for safe transport, including weight observation and securing in vehicles.
Tasks to perform after work and annual safety inspections by an electrician.
Step-by-step instructions for replacing the vacuum bar and brush roller.
Measures to take to protect the appliance from frost damage.
Table detailing common faults, their causes, and recommended solutions.
Procedures for cleaning the water distributor and the suction tube.
Detailed technical data including power, dimensions, weight, and vibration values.
Information on warranty coverage, repair procedures, and requirements for claims.
Emphasis on using original accessories and spare parts for safe and reliable operation.
General| AC input voltage | 220 - 240 V |
|---|---|
| AC input frequency | 50 / 60 Hz |
| Maximum input power | 820 W |
| Noise level | 70.5 dB |
| Maximum area performance | 200 m²/h |
| Fresh water tank capacity | 4 L |
| Brush rotation speed (min) | 1450 RPM |
| Practical area performance | 150 m²/h |
| Brush contact pressure (min) | 100 g/cm² |
Weight and Dimensions| Depth | 335 mm |
|---|---|
| Width | 390 mm |
| Height | 1180 mm |
| Weight | 11500 g |
To Next Page
