38
2. Gun Safety Lock
The user needs to release the safety lock and then pull the trigger to perform the
spray operation. When you release the trigger, it can automatically return to the “off”
position.
When you are not using the high pressure washer, engage the safety lock to prevent
accidental activation of the high pressure spray.
3. Hold the gun
Whenever you use the high pressure washer, we suggest that you hold it in the correct
position, with one hand on the handle and the other on the spray lance.
4. To wash with detergent
a.Turn the container body away from the applicator nozzle, then add water with a
suitably prepared cleaner or detergent, place it inside the container and close it. Attach
the detergent applicator to the gun.
b. Squeeze the trigger of the gun and the detergent comes out of the nozzle.
c. Apply the detergent so that it completely covers the cleaning surface.
d. Let the detergent sit on the surface for a few minutes. This is a good time to use a
brush to lightly clean heavily soiled areas.
e. Switch to the spray nozzle and rinse the detergent from the surface.
f. Cleaning: When finished, always run clean water through the detergent applicator to
remove any detergent residue that may be in the system. The container can be
disconnected if necessary. Repeat this process until all detergent is removed from
the system.
To Next Page
Loading...
