39
MAINTENANCE
All maintenance operations not contemplated in this chapter must be carried out by
an Authorized Technical Service.
1. Cleaning the water inlet filter
The water filter is installed inside the water inlet connection and must be cleaned
periodically. Rinse it with clean tap water and replace it in the water inlet.
Note: Using the equipment without the filter will cause a reduction in the
useful life of the product and the loss of the warranty.
2. Cleaning the nozzle
Using the supplied nozzle cleaner (or an open paper clip), insert the wire into the
nozzle hole and move it back and forth until any debris dislodges. Backwash the
nozzles with water using a garden hose and the highest pressure available (with a
standard faucet or use your thumb over the tip to create water pressure to backwash)
Warning ‒ Danger!
Always disconnect the plug from the outlet before carrying out any work
on the equipment.
3. Cleaning the machine vents
The machine must be kept clean so that cooling air can pass freely through the
machine's vents.
Akbeng052024
STORAGE
1. Turn off the equipment by leaving the switch in the “OFF/0” position, close the
water supply faucet and squeeze the trigger to remove pressure from the system.
2. Disconnect the power supply.
3. Disconnect the hoses and accessories mounted on the equipment
Note: If the equipment is going to be stored for a long period, remove all water present
inside. Turn on the appliance without the supply hose and pull the trigger with the
appliance running for up to 1 minute until there is no more water. Unplug the plug
from the outlet. Place the accessories on the supports available on the equipment.
To Next Page
Loading...
